SelectBlinds.com does not sell individual parts. This page is information only to help our customers see the different blind and shade parts and know what they are used for.
Mounting bracket
The horizontal mounting bracket is the same for inside and outside mount. The Mounting bracket for horizontals may be used to mount the window treatment to either the wall or the ceiling simply by just using the holes provided on the top or sides of the bracket. One side is hinged to allow for installation.
1″ Horizontal window treatment mounting bracket
View 1
View 2
Extension bracket
Extension brackets are used to push an outside mount further away from the wall.
View 1
View 2
Hold down bracket
Hold down brackets are mounted to the door or wall and attach to the window covering. They are used to secure the bottom of the covering.
View 1
View 2
Lift cord mechanism
Located inside the headrail, the lift cord mechanism is used to raise and lower horizontal window treatments.
View 1
View 2
Center support bracket
The center support bracket is used for large products. It is mounted at the center of the product to hold the headrail and support it in the middle. It can be mounted to the ceiling or wall.
View 1
View 2
Valance Clip
Horizontal blind tilter mechanism
View 1
View 2
Tilter mechanism
View 1
View 2
Large mounting bracket
Vertical window treatments headrail for the “outside mount” have an L-shaped piece that mounts to the wall with a small flange that attaches to the headrail. Inside mount only requires the flange to be sent. Because of the light weight of the blind and the easy sliding motion there is not a lot of stress put on the mounting hardware. The small flange is mounted directly into the ceiling or top of the window sill to mount the verticals.
View 1
View 2
Small Mounting bracket
View 1
View 2
The honeycomb mounting brackets may be mounted through the back side of the bracket to a wall for an outside mount or through the top for an inside mount.
Once the brackets are installed, simply snap the honeycomb headrail into the bracket by tilting the headrail at an angle then press up the back of the shade headrail into the brackets.
Mounting bracket for cordless and continuous cord loop
3/4 inch express light filtering honeycomb bracket
View 1
View 2
Spring roller shade inside mounting bracket
Spring roller mounting brackets only require two screws per side. Be sure to screw them into the wall so that the bracket with the easy mount slide in slot is on the left so that you can slide the treatment in and down for a secure fit.
The outside/ceiling mount brackets have holes on the sides and top for mounting convenience. You can use either the holes on the side or top but only need two screws per side for a secure mount.
View 1
View 2
Spring roller mechanism
The spring side of the shade is the mechanism used to raise and lower the shade. This piece is concealed by the drum around which the shade rests. You will not see this piece unless you take your shade apart. SelectBlinds does not sell individual parts. If you bought your roller window treatment from us and need a part replaced we will send them to you.
